Publicidad
Idiomas disponibles
Idiomas disponibles
REPAIR
Problem
Possible cause
The plug is not connected
The switch is defective
Defective extension
The catch is not well engaged
The engine will
not start
Overheating security
Blades blocked
The engine will
The lubrication of the transmission
not start
is insufficient
Screws, nuts or loose bolts
The blades are damaged
Excessive
Too large working depth
vibrations
Fibers or an external element
makes it difficult to rotate the
wheels
Too low working depth
Unsatisfactory
results
Worn blades
30/10/2023
Solution
Connect the socket
Replace the switch
Test with a new extension
Check the connections between the socket, the
extension and the binine
The working depth is too large, reduce it
- Blades are blocked by one or more foreign
bodies, remove it (them)
- The ground is too hard, go back and forth
slowly, to improve performance
- Wait 15 minutes for the engine to cool before
reusing the machine
Turn off and wait until all the elements are stop-
ped. Remove the blocks that block
Refer to the maintenance / transmission section,
to fill the box
Check all the screws and fixing elements, then
tighten them
Return / sharpen the blades before leaving, if the
vibration persists, replace the strawberry
Review the working depth by pressing less firmly
Check that each wheel turns freely, and pledge
the elements that can hinder
Hold the device more firmly to dig more deeply.
You can also rotate left to right to facilitate work
Sharp the blades, or replace them
EN
45
Publicidad
