Publicidad
Idiomas disponibles
Idiomas disponibles
AUTOMATIC CUT-OFF
A cut-off switch is fitted to the heating element to prevent damage due to overheating. If it cuts-off due to an
obstruction in the airflow, the heater must be allowed to cool for 15 minutes, and the obstruction must be
removed before restarting.
SERVICE INSTRUCTIONS
CAUTION: Even though the glass is safety glass it may break if bumped, struck or dropped. Care must be
taken when handling the glass.
The bulbs fitted to this heater are LED HD-AJ05-A .
1. Unplug the unit.
2. If the stove has been operating, let the unit cool at least 1 hour.
3. Loosen and remove the screws holding the stove back panel to the main body of stove.
4. Remove LED bulb strip and replace with
5. Place rear access panel back into position and tighten screws (Do not over tighten
WARNING: Disconnect power and allow unit to cool completely
before attempting any maintenance or cleaning to reduce the risk
of fire, electrical shock or personal injury.
REPLACING LIGHT BULBS
HD-AJ05-4
WARNING:
The bulbs fitted to this heater are
bulbs the use of any other type of bulb may result in a fire
causing property damage and personal injury.
~ 7 ~
).
LED HD-AJ05-A
Publicidad
