Next Level Racing ELITE Serie Manual De Instrucciones página 23

)
A
A) Align the holes on the HOTAS Plate with the threaded inserts on the HOTAS Angle Bracket. Bolt through and secure with
2 x M8 Countersunk Bolts.
37
B) Align the threaded inserts and slots on the HOTAS Angle Bracket with the slots on the Centre Pole Bracket.
C) Bolt through and secure with 1 x M8 Bolt, Washer and Flange Nut.
D) Bolt through and secure with 2 x M8 Shoulder Bolts.
ADJUSTMENT RANGE
38
Loosen bolts and adjust the setup to the desired position. Tighten the bolts to secure in place.
MOTION V3 SETUP
39 Install 4 x T-Nuts into both the top and bottom channel of the front Seat Slider member. Install 2 x
T-Nuts into the bottom channel of the rear Seat Slider member and slide them to the marked locations.
)
B
)
C
T-NUTS LOCATION
Rear Seat Slider
Front Seat Slider
23
Video Instruction: bit.ly/nlrbuild
PARTS:
)
D
• • 1 x Hotas Plate
• • 1 x Hotas Angle Bracket
• • 2 x M8 20mm Shoulder Bolts
• • 2 x M8 Countersunk Bolts
• • 1 x M8 60mm Bolts
• • 1 x M8 Washer
• • 1 x M8 Flange Nut
PARTS:
• • NIL
PARTS:
• • 10 x T-Nuts
TOP VIEW
BOTTOM VIEW
TOP VIEW
BOTTOM VIEW
(Use T-Nuts compatible with the channel of your cockpit)
OR