Trevi TT 1042 DAB Manual De Usuario página 9

ENGLISH
USB INPUT OPERATION
1. Connect a USB memory device to the USB input (12).
2. Switch on the device and press the MODE key (16) several times until the USB indication appears on the display, which indicates
the loading of the data present in the USB device. If there is no USB device, NO DEVICE will appear on the display.
Note:
- The unit may not support some SD / USB devices, this is due to the incompatibility of some processors.
3. Playback of the music track will start automatically, to pause it press the / key (8). Press it again to reactivate song playback.
4. Press the 9 or buttons : to skip to the previous / next track, long press them to scroll quickly forwards or backwards in the
track being played, release them to return to normal playback.
5. Press the SCAN / ENTER button (18) to activate single track repeat (REP-1), all track repeat (ALL) or random playback (RANDOM).
TURNTABLE OPERATION
Remember to carefully remove the stylus protector.
1. Switch on the device and press the MODE button (16) several times until PHONO appears on the display.
2. Select the speed of the disc using the turntable speed selector (6).
3. Place the disc on the platter. Use the supplied adapter if the record is a 45 rpm record.
4. Release the cartridge arm from the clip, raise the arm and place the stylus on the record. Using the lever (3) lower the print arm.
Playback of the disc will start.
5. At the end of the disc playback, the turntable will stop spinning if the AUTOSTOP function is active (selector 5); bring the lever
(3) to the raised arm position.
Note1: It may happen that the Autostop function stops the rotation of the disc before the end of the recording. In this case, deactivate the
function by setting the selector (5) to OFF.
Note2: Remove the turntable stylus cover before use.
Note3: Make sure the arm is locked by the arm stop after each use
AUX IN
1. Switch on the device and press the MODE key (16) several times until the indication AUX appears on the display.
2. Connect any unit with an audio output using a suitable cable to the AUX IN input (11).
3. Control the outdoor unit by your own commands.
4. Adjust the volume with the control on the unit (13).
HEADPHONE SOCKET
1. Plug the headphones into the headphones socket (15). The speakers will be muted.
2. Start the desired playback and adjust the volume.
LINE OUT
The LINE OUT output allows you to connect the device to an external amplification system.
Connect an RCA cable not supplied to the sockets (20) and the other end to the external system. Start the desired playback.
TECHNICAL SPECIFICATIONS
Power supply:
Consumption:
Standby comsumption:
FM reception frequency:
DAB reception frequency:
Transmission power BT:
Bluetooth transmission frequency: 2.4 GHz
Unit dimensions:
12V 1A supplied with external adaptor 100-240V ~ 50 / 60Hz
12W
<1W
87.5 - 108.0 MHz
174 - 240 MHz
2.5 mW
390x365x145 mm
TT 1042 DAB
9