aquatechnik BST 32 PLUS Instrucciones De Uso página 41

Operation 1
CAUTION
the equipment back in the rest position (reset time 4-5 seconds), ready to perform other flaring
processes. It is however possible to place the equipment in this operating position manually.
1) Unscrew the cap of the emergency device (C) by accessing the gear below (fig. 7a);
2) Screw the cap head onto the screw until the machine is completely reset (fig. 7b);
3) At the end of the procedure, return the cap to the starting conditions.
Operation 2
Threaded rod end (X)
If operation 1 is not sufficient to unlock the Pipe Flaring Machine BST 32 PLUS, repeat steps 1
and 2 of operation 1 and then:
A) unscrew the cap (L) on the back of the piston of the Pipe Flaring Machine
BST 32 PLUS (fig. 8);
B) screw in the unlocking tool (N) till the end
(fig. 9a-9b);
EMERGENCY UNLOCKING
CAUTION: the Pipe Flaring Machine BST 32 PLUS is equipped with
an automatic device that, when the flaring process is complete, puts
fig. 7a
Unlocking tool (N)
Threaded cap (Y)
fig. 7b
Threaded rod (W)
(fig. 9a)
EN
(fig. 8)
(fig. 9b)
41