De Dietrich DFP8363W Guia Del Usuario página 188

6
•
CARE
PYROLYTIC SELF-CLEANING
This oven is equipped with a pyrolytic
self-cleaning function:
Pyrolysis is a cycle during which the
oven cavity is heated to a very high
temperature in order to eliminate soiling
from splattering and spills.
Before starting pyrolysis cleaning,
remove any large overspills, if any.
Remove the excess grease on the door
using a damp sponge.
As a safety measure, cleaning only
occurs after the door locks automatically;
it is impossible to unlock the door.
Remove the accessories and
supports from the oven before
beginning pyrolysis cleaning.
PERFORM A SELF-CLEANING
CYCLE
Proposed cycles:
PyroExpress in 59 minutes.
This specific function uses the heat
built up during a previous cooking cycle
to quickly and automatically clean the
inside of the oven: it cleans a mildly dirty
oven interior in less than an hour.
The electronic oven temperature monitor
determines whether the residual heat
remaining in the oven interior is sufficient
to provide a good cleaning result. If
this is not the case, a 90-minute ECO
pyrolysis cycle will automatically
begin.
Pyrolysis 2h00
for more in-depth cleaning of the inside
of the oven.
IMMEDIATE CLEANING
The programmer must only display the
time. It should not be flashing.
Turn the function selector to one of the
self-cleaning functions.
The pyrolysis cycle begins. The time
starts to count down as soon as it is set
(press the knob).
During pyrolysis, the symbol
displayed in the programmer to indicate
that the door is locked.
At the end of pyrolysis, a cooling phase
takes place and your oven remains
unavailable during this time.
When the oven is cool, use a
damp cloth to remove the white
ashes. The oven is clean again and
ready for further cooking operations.
DELAYED CLEANING
Follow the instructions in the previous
paragraph and then set the end time
for the pyrolysis cycle by pressing
The display flashes. Set the end time
with + and - . After these steps, the
start of pyrolysis is delayed so that it
finishes at the programmed time. When
the pyrolysis cycle has finished, put the
function selector back to 0.
27
is
.