Makita JV001G Manual De Instrucciones página 9

To remove the jig saw blade, open the tool opener
forward as far as it will go. This allows the jig saw blade
to be released.
2
Fig.9
► 1 . Jig saw blade holder 2. Tool opener 3. Jig saw
blade
NOTE: In case that it is difficult to remove the jig saw
blade:
Turn the cutting action changing lever to the position
"III" and slightly switch on the tool several times so
that the jig saw blade holder moves to the bottom.
Make sure the jig saw blade clamp lever is in the fixed
position when switch on the tool.
Remove the battery cartridge from the tool before
installing or removing the jig saw blade.
NOTE: Occasionally lubricate the roller.
Hex wrench storage
When not in use, store the hex wrench as shown in the
figure to keep it from being lost.
Fig.10
► 1 . Base 2. Hex wrench
1
3
1
2
Cover plate
Use the cover plate when cutting decorative veneers,
plastics, etc. It protects sensitive or delicate surfaces
from damage. Fit it on the bottom of the tool base.
Fig.11
► 1 . Cover plate 2. Base
Anti-splintering device
CAUTION:
The anti-splintering device cannot
be used when making bevel cuts.
For splinter-free cuts, the anti-splintering device can
be used. To install the anti-splintering device, move the
tool base all the way forward and fit it from the bottom
of tool base.
When you use the cover plate, install the anti-splintering
device onto the cover plate.
Fig.12
► 1 . Base 2. Anti-splintering device
9 ENGLISH
1
2
1
2