Rohde ST 310 Instrucciones De Uso página 54

4. Assembly
4.1. General safety information
WARNING
An incorrectly placed control unit can lead to serious personal injury or property
damage.
The control unit should never be placed on the kiln but should only be positioned in the
bracket provided for it. The controller must not be exposed to direct heat from exhaust air or
thermal radiation from the kiln.
4.2. Mounting the bracket
4.3. Connecting the connection cable
Step Description
1 Insert the plug of the control unit into the socket on the kiln.
The plug and socket have a geometric coding; they only fit into each other
2
in a certain position.
The wide lug on the plug must be at the top in the 12 o'clock position to
3
fit into the wide recess on the socket, also in the 12 o'clock position.
You may have to twist the plug a little until it completely clicks into the
4
socket.
5 Tighten the outer screw ring on the plug clockwise.
4.4. Extension cable for the control unit
• If the bracket for the control unit is attached at the operation location (near the kiln or mounted on a wall), the
connecting cable can be extended using an extension cable.
• The extension cable for the control systems is optionally available in lengths of 2.5, 5 or a maximum of 10
metres.
• Note on extension cables and environmental influences due to EMC:
­ To meet the requirements for electromagnetic compatibility (EMC), the length of the controller
connection cable should not exceed 3 metres.
­
If the controller is connected to the kiln with an extension cable, it should be ensured that there is no
electrical device in the direct vicinity of the cable (electromagnetic stray field). Failure to do so could
result in a loss of temperature control accuracy of up to 3°C in the control system.
⇒ The control unit comes with a suitable bracket which can be attached to the
kiln or at the operation location (near the kiln or on a wall).
⇒ The bracket is attached with 2 bolts.
⇒ Observe the direction of the arrow while mounting the bracket (direction of
arrow = up).
⇒ Never place the control unit on the kiln but use the bracket instead.
⇒ When mounting on the kiln, the bracket is mounted on a suitable controller
mounting plate or the switch box. Please refer to the operating instructions
for the kiln.
⇒ When mounting on a wall, the bracket is screwed directly to a wall near the
kiln using the fastening material supplied.
⇒ The appropriate mounting material is included in the scope of delivery.
52 / 293 - EN -
Plug view