PURE Contour 200i Air Manual De Instrucciones página 11

Preparing Contour to use
AirPlay with an Ethernet cable
1. Connect an Ethernet cable from
the Ethernet port on the back of
Contour to your router.
2. Insert the connector of the mains
power adapter into the DC In
socket on the rear of Contour.
3. Plug in to the mains supply.
4. A network connection between your router and Contour will then be established automatically.
When the red Status LED on the front has stopped flashing, Contour is in Sleep mode.
5. Press Standby on Contour or the remote control until Contour has AirPlay selected as its
input source. If the Status LED is steady white AirPlay has been setup successfully (this can
take up to one minute). If the Status LED is still flashing white after one minute, there is a
problem with Contour's network connection.
Note: See "Help" on page 25 for help with troubleshooting Contour network connectivity
issues.
6. Contour is now set up to use AirPlay with a wired connection. No further configuration is
required. See page 12.
Typical Ethernet setup
18V DC
EN
11