Publicidad
EN
Fitting Kit
K638W
Press foot down while tightening centre
screw with hex key.
NOTE: Clamp must be fully open to access
centre screw.
Tighten firmly (3Nm).
Use two M5 x 12 mm self tapping screws to
secure the assembly onto the leg.
Lightly tighten (1Nm) self-tapping screws,
so screw heads are just touching side of
leg.
Repeat for all legs.
If rubber pads become loose or detached,
press firmly into place as shown.
Refer to the inside curve of the pad for the
part number.
7
Publicidad
