Publicidad
EN
Fitting Kit
K638W
Ensure the pins of the clamps engage
correctly with the holes in the roof rail.
Rotate clamp to engage one pin in fix-point
hole. Downward pressure may have to be
applied to crossbar to assist. Second pin
will engage as adjusting screw is tightened.
Ensure pad is tight against outside of rail
before tightening.
Firmly tighten (3 Nm) adjusting screw.
Once crossbars are in position, alternately
tighten clamp screws firmly (5Nm) to the
rail using 5mm hex driver.
9
Publicidad
