Publicidad
Idiomas disponibles
Idiomas disponibles
Instructions for use
All manuals and user guides at all-guides.com
Restoring all original functions
To revert the SRU 7060 back to the factory default settings, do the following:
1
Press keys 1 and 6 simultaneously for
5 seconds until the label of the selected mode
blinks twice and remains lit.
2
Press keys 9, 8 and 1, in that order.
•
The mode light will blink twice to confirm a
succesfull reset.Your remote is now reverted
to the state it was when you first took it out
of the packaging.
5. Troubleshooting
•
Problem
–
Solution
•
The device you want to operate does not respond and the device label
does not blink when you press a key.
–
Replace the old batteries with two new 1.5 Volt, R03, UM4 or AA batteries.
•
The device you want to operate does not respond but the device label
does blink when a key is pressed.
–
Point the SRU 7060 at the device and make sure that there are no
obstructions between the SRU 7060 and the device.
•
The SRU 7060 does not respond properly to commands.
–
Maybe you are using the wrong code.Try programming the SRU 7060 again
using another code, which is mentioned under the brand of your device, or
reset for automatic search to find the right code.
If the device still does not respond, call our helpline, or for online setup go to:
www.philips.com/urc.
•
You have difficulties operating all of the functions on your device.
–
Maybe the SRU 7060 has to be adapted to the model of the device.
Call our helpline for details. For online help go to: www.philips.com/urc.
•
Your brand of device is not in the code list.
–
Try to set the SRU 7060 automatically.
See 'Automatically setting the remote control'.
•
None of the codes works during manual setting of the remote control.
–
If that is the case, follow the instructions under
'Automatically setting the remote control'.
12
Publicidad
