Johnson JAMA230BN Manual De Instrucciones página 36

This appliance is to be built into a kitchen unit or 600mm worktop, providing the
following minimum distances are allowed;
o
The edges of the hob must be a minimum distance of 60 mm from a side or rear wall.
o
700 mm between the highest point of the hob surface (including the burners) and the underside
of any horizontal surface directly above it.
o
400 mm between the hob surfaces, providing that the underside of the horizontal surface is in
line with the outer edge of the hob. If the underside of the horizontal surface is lower than 400
mm, then it must be at least 50 mm away from the outer edges of the hob.
o
50 mm clearance around the appliance and between the hob surface and any combustible materials.
o
You must have a gap of at least 25 mm and at most 74 mm between the underneath of the
appliance and any surface that is below it.
- An oven must have forced ventilation to install a hob above it.
- Check the dimensions of the oven in the installation manual.
- The cut out size must obey the indication.
Installing the appliance
Remove the pan supports, the burner lid and flame spreader and carefully turn the appliance upside
1.
down and place it on a cushioned mat.
2. Take care that the Ignition devices and flame supervision devices are not damaged in this operation.
Apply the sponge provided around the edge of the appliance.
3. Do not leave a gap in the sealing agent or overlap the thickness.
(A) SEALING STRIP
(C) SCREW
(B) BRACKET
25mm(MIN)
Do not use a silicon sealant to seal the
appliance against the aperture.
This will make it difficult to remove the
appliance from the aperture in future,
particularly if it needs to be serviced.
Place the bracket (B) over the holes that match the
size of the screws.There are one set of screw holes in
each corner of the hob (H).Slightly tighten a screw (C)
through the bracket (B) so that the bracket is attached
to the hob, but so that you can still adjust the position.
2. Carefully turn the hob back over and then gently lower
it into the aperture hole that you have cut out.
3. On the underneath of the hob, adjust the brackets into
a position that is suitable for your worktop.
Then fully tighten the screws (C) to secure the hob into
position.
EN-15
45mm
V.1