Johnson JAMA230BN Manual De Instrucciones página 37

Gas Connection
This appliance must be installed and connected in accordance with installation regulations
in force in the country in which the appliance is to be used.
This appliance is supplied to run on LPG and natural gas. Conversion for use on LPG and
natural gases must only be undertaken by a qualified person.
Gas supply replacement and installation guidelines:
The gas inlet
pipe assembly
G1/2"Female coupler
Installation of appliance
Note: Wear protective gloves to
fit the hob.
(1) Adjusting the direction of elbow
After loosening the elbow, adjust the elbow interface to the required direction as required, and keep the
hexagonal head of the elbow motionless with a wrench. Use a 9±1N.m torque wrench to tighten the
black bolt of the gas inlet pipe assembly. Ensure that the torque of the wrench is within the required
range to prevent elbow breakage or damage caused by excessive force.
After the installation is tightened, check whether the parts are in good condition and test the air tightness
to ensure the tightness of the installation. The installer is responsible for the results of the process.
LPG > NG
seal
The hexagonal
head of the elbow
Hold still
NG > LPG
The gas inlet
pipe assembly
Elbow
Torque:
Black nut of
9±1N.m
manifold
Tighten with a
torque wrench
of 9±1N.m
The black bolt of the
gas inlet pipe assembly
EN-16
seal
Ø11.5 Female coupler
Caution!
lf necessary to adjust or
install the elbow, it is allowed
only torque wrench with
9±1N.m, and work on the
Black nut of manifold instead
of on the elbow.
V.1