Descargar Imprimir esta página

Craftsman 139.30437 Manual Del Propietário página 17

Ocultar thumbs Ver también para 139.30437:

Publicidad

Idiomas disponibles

Idiomas disponibles

INSTALLATION STEP 6
Install the Lights
1. Press the release tabs on both sides of lens. Gently rotate lens
back and downward until the lens hinge is in the fully open
position. Do not remove the lens.
2. Insert an A19 incandescent (100W maximum) or compact
fluorescent (26W, 100W equivalent) light bulb into the light
socket. The lights will turn ON and remain lit for approximately
4-1/2 minutes when power is connected. Then the lights will
turn OFF.
3. Reverse the procedure to close the lens.
4. If the bulbs burn out prematurely due to vibration, replace with
a garage door opener bulb. Use A19, standard neck garage
door opener for replacement.
NOTE: Do not use halogen, short neck, or specialty light bulbs as
these may overheat the end panel or light socket. Do not use LED
bulbs as they may reduce the range or performance of your
remote control(s).
INSTALLATION STEP 7
Attach the Emergency Release Rope and Handle
1. Insert one end of the emergency release rope through the handle.
Make sure that "NOTICE" is right side up. Tie a knot at least 1 inch
(2.5 cm) from the end of the emergency release rope.
2. Insert the other end of the emergency release rope through the hole in
the trolley release arm. Mount the emergency release within reach, but
at least 6 feet (1.83 m) above the floor, avoiding contact with vehicles
to prevent accidental release and secure with a knot.
NOTE: If it is necessary to cut the emergency release rope, seal
the cut end with a match or lighter to prevent unraveling. Ensure
the emergency release rope and handle are above the top of all
vehicles to avoid entanglement.
To prevent possible OVERHEATING of the end panel or light
socket:
• Use ONLY A19 incandescent (100W maximum) or compact
fluorescent (26W maximum) light bulbs.
• DO NOT use incandescent bulbs larger than 100W.
• DO NOT use compact fluorescent light bulbs larger than
26W (100W) equivalent.
• DO NOT use halogen bulbs.
• DO NOT use short neck or specialty light bulbs.
Release Tab
100 Watt (Max)
Standard Light Bulb
or
To prevent possible SERIOUS INJURY or DEATH from a falling
garage door:
• If possible, use emergency release handle to disengage
trolley ONLY when garage door is CLOSED. Weak or broken
springs or unbalanced door could result in an open door
falling rapidly and/or unexpectedly.
• NEVER use emergency release handle unless garage
doorway is clear of persons and obstructions.
• NEVER use handle to pull door open or closed. If rope knot
becomes untied, you could fall.
Emergency
Release Handle
17
Compact Fluorescent
Light Bulb
Lens
Hinge
Compact Fluorescent
Light Bulb
Trolley
Trolley
Release
Arm
Overhand
Knot
or
100 Watt (Max)
Standard Light Bulb

Publicidad

loading