Hilti TE 60T Manual De Instrucciones página 28

7.2.5 Drilling without hammering (TE 60‑ATC /
TE 60T‑ATC)
1. Turn the function selector switch until it engages in
the "Drilling without hammering" position. Do not
operate the function selector switch while the motor
is running.
2. Bring the side handle into the desired position and
check that it is fitted correctly and secured.
3. Plug the supply cord into the power outlet.
4. Position the power tool and drill bit at the point
where the hole is to be drilled.
5. Press the control switch slowly (drill at a low speed
until the drill bit centers itself in the hole).
6. Press the control switch fully to continue working at
full power.
7. Do not apply excessive pressure. This will not in-
crease the power tool's drilling performance. Lower
pressure extends the life of the insert tool.
7.2.6 Drilling without hammering (TE 60 / TE 60T)
Drilling without hammering is possible when drill bits with
a special connection end are used. Drill bits of this kind
are available from Hilti. For example, when the keyless
quick-release chuck is fitted, smooth-shank drill bits for
wood or steel can be used to drill without hammering.
The function selector switch must be set to the "Hammer
drilling" position when the power tool is used in this way.
8 Care and maintenance
CAUTION
Disconnect the mains plug from the power outlet.
8.1 Care of core bits and metal parts
Remove any dirt adhering to the surface of the core bits,
the chuck and drive spindle and protect their surfaces
from corrosion by rubbing them with an oily cloth from
time to time.
8.2 Care of the power tool
CAUTION
Keep the power tool, especially its grip surfaces,
clean and free from oil and grease. Do not use clean-
ing agents which contain silicone.
8.3 Service indicator
NOTE
The power tool is equipped with a service indicator.
7.2.7 Control switch lock 8
When chiseling, the control switch can be locked in the
"on" position.
1. Push the control switch lock above the grip forward.
2. Press the control switch fully.
The power tool then operates in sustained mode.
3. To cancel sustained operating mode, slide the con-
trol switch lock to the rear.
The power tool then switches off.
7.2.8 Mixing
1. Turn the function selector switch until it engages in
the "Hammer drilling" position.
2. Insert the quick-release chuck in the power tool's
chuck.
3. Insert the mixing paddle.
4. Check that the insert tool has engaged correctly by
pulling it.
5. Bring the side handle into the desired position and
check that it is fitted correctly and secured.
6. Plug the supply cord into the power outlet.
7. Position the mixing paddle in the container holding
the substance to be mixed.
8. To begin mixing, press the control switch slowly.
9. Press the control switch fully to continue working at
full power.
10. Guide the mixing paddle carefully in order to avoid
splashing and spillage.
The outer casing of the power tool is made from impact-
resistant plastic. Sections of the grip are made from a
synthetic rubber material.
Never operate the power tool when the ventilation slots
are blocked. Clean the ventilation slots carefully using
a dry brush. Do not permit foreign objects to enter the
interior of the power tool. Clean the outside of the power
tool at regular intervals with a slightly damp cloth. Do
not use a spray, steam pressure cleaning equipment or
running water for cleaning. This may negatively affect the
electrical safety of the power tool.
en
25