Publicidad
Idiomas disponibles
Idiomas disponibles
EN
4
USE
4.1
Initial start-up
After completing the installation of SIME SRS , proceed as fol-
lows.
Once the batteries have been inserted, the icon test appears
and all the symbols light up.
1 2 3 4 5 6 7
H
C°
C°
M
4.2
Firmware version
Once the icon test terminates, the firmware version of the room
sensor appears for a few seconds. The first line (small digits)
identifies the revision of the RF module (e.g. 6.0), while the sec-
ond line (large digits) identifies the firmware version (e.g. S01).
1 2 3 4 5 6 7
H
4.3
RF communication
Once the system starts up, after the firmware version appears,
it verifies the pairing and communication status with the re-
spective remote control.
If SIME SRS is not paired with any system, the RF ANTENNA icon
flashes, the large digits show the measured room temperature
(e.g. 23°C) and the status icons are all switched off.
1 2 3 4 5 6 7
C°
C°
C°
M
C°
H
M
27
Publicidad
