Publicidad
Idiomas disponibles
Idiomas disponibles
EN
System errors are displayed with the letter "Exx":
– " E10 ". Anomaly of the internal NTC probe
– " E20 ". Internal error in the communication with the RF mod-
ule
– " E21 ". No communication with the management system: if
the room sensor is paired with a remote control, but no re-
sponse is received for two successive communications, the
anomaly status is signalled.
4.5
Configuration menu
Prolonged pressing of the
@
ondary menu where it is possible to configure the device. In this
menu "MOD" appears in the small digits and the function to be
configured flashes.
The
[
and
]
keys can be pressed to change the function.
Pressing the
@
key allows for accessing the selected config-
uration menu.
Pressing
P
restores the main screen. The Stand-by mode is
activated 8 sec. after the last key was pressed.
The functions that can be configured and the respective icons
are shown below.
Icon
Description
Temperature sensor calibration
°C
Radio signal level
key allows for accessing the sec-
4.5.1
Temperature sensor calibration
allows for entering an offset for calibrating its inter-
SIME SRS
nal temperature sensor and thus correcting any measurement
errors. It is possible to enter values from -9,9°C to +9,9°C with
0,1°C steps. The default value is set to 0,0°C.
The correction value appears on the large digits and can be
modified within the range using the
ured temperature to which the selected correction is applied
will appear in the small digits.
The new value must be confirmed by pressing the
natively, the current value is restored by pressing the
1 2 3 4 5 6 7
H
[
and
]
keys; the meas-
@
key. Alter-
P
key.
C°
C°
M
31
Publicidad
