General Information; Definitions; Installation; Initial Operation - IO-Homecontrol HSM4-io Instrucciones De Montaje

Mando a distancia
Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 38
E N G L I S H
Do not wind the aerial wire of the ESE1-io
receiver/transmitter unit around metal
objects such as nails, struts, etc. Use trial-
and-error to determine the ideal orientation.
If used simultaneously, GSM 900 mobile
phones may affect the useful range of the
remote control. Do not use other remote
controls simultaneously during teach-in,
as this can cause errors.
Local conditions may affect the useful
range of the remote control!
2

General information

The io-homecontrol
®
technology is a
wireless communication protocol and
enables products of different home
technology manufacturers, e.g. garage
doors and entrance gates, to interact
smoothly.
One of the main advantages of io-home-
control
®
compared to previous remote
control solutions is the "confirmation"
(status) function. The bi-directional language
of io-homecontrol
®
makes it possible for
08.2007 TR20G005-A RE
devices to respond to control commands
and confirm the execution of a task.
Transmission is on three frequencies (from
868 MHz to 870 MHz).
When operated for the first time, the
transmitter (the remote control) and the
receiver (the io-homecontrol
®
e.g. a garage door operator) exchange a
unique system key. This registers the
product as part of the installation; it can
now only be controlled via the assigned
remote controls.

2.1 Definitions

System key
To prevent influence from other remote
controls, every io-homecontrol product
operated in one house must use the same
system key. The first product put into
operation must transfer this system key to
all of the other products.
Ex-factory settings
There is no system key and no product
assignment stored in the device.
ESE1-io: When the receiver/transmitter
unit's plug is plugged into the
operator's "BUS" socket, the
red LED will flash.
HSM4-io: When the status button is
pressed, the left LED will light
up as long as the button is held
down. There is no additional
product,
display.
3

Installation

Mount the receiver/transmitter unit as
shown in figure
4

Initial operation

4.1 General information
HSM4-io hand transmitter
Using the HSM4-io hand transmitter, you
can control specific functions of the
respective operator unit via the ESE1-io
receiver/transmitter unit. Additionally, you
can request the status of a door or gate
(open/closed) via the status button "S".
This status is displayed by the status LED
"S" (Fig.
4a/4b
1/2
.
).
13
13

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Ese1-ioEse1-io-gEse1-io-e

Tabla de contenido