Teaching In A Gate/Door Operator With Additional Functions - IO-Homecontrol HSM4-io Instrucciones De Montaje

E N G L I S H
Use the adhesive labels supplied to assign
functions to the corresponding hand trans-
mitter buttons. Power is supplied via a 12 V
battery (type 23A). Observe the correct
polarity when inserting the battery (Fig.
ESE1-io receiver/transmitter unit
Insert the plug of the ESE1-io receiver/
transmitter unit into the BUS socket of the
operator unit (Fig. 3 ). Use the double-sided
adhesive tape to fasten the ESE1-io
receiver/transmitter unit.
5.1 Teaching in a gate/door operator
with additional functions (Fig.
(The ESE1-io receiver/transmitter unit and
the HSM4 hand transmitter are in ex-factory
settings)
• Affix the corresponding adhesive label to
the hand transmitter (Fig. 4a
• Insert the plug of the ESE1-io receiver/
transmitter unit into the BUS socket of
the operator unit (Fig. 3 ).
- The red LED of the ESE1-io will flash
slowly.
14
• Carefully press the "PRG" button on the
HSM4-io hand transmitter with a blunt
object for max. 1 s (Fig.
- Both LEDs of the hand transmitter will
5 ). flash green, slowly.
- The search for io-homecontrol® pro-
ducts is initiated. This may take up
to 2 min.
- If an ESE1-io receiver/transmitter unit
is recognised, the red LED of the
receiver/transmitter unit will light up.
- If both LEDs of the HSM4-io hand
transmitter flash green quickly, the
system key has been transferred.
4a )
• Press button "P" on the ESE1-io receiver/
transmitter unit once (Fig.
- The red LED will flash slowly.
• On the HSM4-io hand transmitter, press
the top button (with a raised dot) for
). operator impulse mode (Fig.
- Both LEDs of the hand transmitter will
flash green, slowly.
The additional functions have been
assigned to the buttons according
to the label.
• The operator has been successfully
assigned to the HSM4-io hand
6a ). transmitter if
- the red LED on the ESE1-io receiver/
transmitter unit remains on
- both LEDs on the hand transmitter light
up green for approx. 4 s.
Note
If the red LED on the ESE1-io receiver/
transmitter unit continues to flash and/
or both of the LEDs of the HSM4-io
hand transmitter light up red for approx.
4 s, this procedure has failed. Briefly
remove the ESE1-io plug from the BUS
socket, then plug it in again and repeat
7 ). all steps.
Status request
To request the status of the gate/door,
briefly press the status button "S" of the
4a ). HSM4-io hand transmitter (Fig.
• Briefly press the desired status button "S".
- Briefly press the desired status button
"S"
- Status LED "S" lights up red for approx.
2 s
4a ).
Gate/door is closed
Gate/door is not closed
08.2007 TR20G005-A RE