Bosch MUM57 Serie Instrucciones De Uso página 28

en Operation
Fine grating disc
for shredding food finely, e.g. nuts or
hard cheese such as Parmesan.
Note: Not suitable for processing soft
cheese and cheese slices.
Grating disc – coarse
for grating raw potatoes, e.g. for
potato pancakes or dumplings.
Asia vegetables disc
for cutting food into thin strips, e.g.
fruit and vegetables.
Working with the
continuous-feed shredder
Fig. G
■ Press the Release button and
move the swivel arm to
position 2.
■ Insert the bowl:
Tilt the bowl forwards and then set it
down. Turn anti­clockwise until it locks
into place.
■ Press the Release button and
move the swivel arm to
position 3.
■ Remove drive cover from the
drive of the continuous­feed shredder
(Fig. G-5a).
■ Hold disc holder at the lower end,
ensuring that the two tips are face up.
■ Carefully place the required slicing or
shredding disc onto the tips of the disc
holder (Fig. G-6a).
In the case of reversible discs, ensure
that the required side is face up.
■ Grip disc holder at the upper end and
insert into the housing (Fig. G-6b).
■ Attach the cover (note mark) and turn all
the way in a clockwise direction.
■ Place continuous­feed shredder on the
drive and rotate all the way in a clockwise
direction, as illustrated in Fig. G-8.
■ Turn rotary switch to recommended
setting.
■ Put food to be processed in the feed tube
and push down with the pusher.
Warning!
Prevent the cut ingredients from building up
in the outlet opening.
28
Tip: To ensure even cutting results, process
thin ingredients in bunches.
Note: If the food to be processed sticks in
the continuous­feed shredder, switch food
processor off, pull out mains plug, wait until
the drive comes to a standstill, remove cover
from the continuous­feed shredder and
empty feed tube.
After using the appliance
■ Switch off the appliance with the rotary
switch.
■ Rotate the continuous­feed shredder in
an anti­clockwise direction and remove.
■ Rotate the lid in an anti­clockwise direc­
tion and remove.
■ Remove disc holder with disc. To do this,
press finger from below against the drive
shaft (Fig. H).
■ Clean parts.
Blender
Observe the application examples in table N
W Risk of injury from sharp blades /
rotating drive!
Never place fingers in the attached blender!
Do not remove / attach the blender until the
drive is at a standstill! Operate the assem­
bled blender only and with the lid attached.
Do not operate blender when empty.
W Risk of scalding!
If processing hot liquids, steam escapes
through the funnel in the lid.
Working with the blender
Fig. J
■ Press the release button and
move the swivel arm to
position 4.
■ Remove the blender drive cover.
■ Attach blender jug (mark on the handle
on mark on the base unit) and turn all the
way in an anti­clockwise direction.
■ Add ingredients.
Maximum amount of liquid = 1.25 litres;
maximum amount of frothing or hot
liquids = 0.75 litres.
■ Attach the cover and turn anti­clockwise
all the way into the blender handle. The
cover must be locked in position.