Toro 98-9230 Instrucciones De Instalación página 11

BBC Models (Fig. 19) – Loosen cable
clamp screw until brake cable conduit
slides. Pull cable to remove slack, but do
not put tension on spring. Tighten screw to
lock adjustment in place.
1
Figure 19
1. Spring
2. Cable clamp screw
Install Starter Rope in Rope Guide
Zone Start Models
1. Reinstall starter rope in rope guide (Fig. 1).
BBC Models
1. Drill a 9/32" hole for rope guide approximately
6-8" down from control bar hole (Fig. 20).
2. Install new rope guide using hex head capscrew,
curved washer and hex lock nut (Fig. 20).
3. Install starter rope in rope guide (Fig. 1).
2
3
278
3. Cable conduit
2
6-8"
4
5
1
Figure 20
1. 9/32" hole
2. Control bar hole
3. Rope guide
Install New Rope Stop
1. Crimp rope stop onto starter rope approximately
2" from recoil opening on engine (Fig. 21).
Figure 21
1. Rope stop
Installation
3
6
4. Hex head capscrew
5. Curved washer
6. Hex lock nut
1
2"
EN–11