Craftmade Sterling STL60 Guia De Instalacion página 10

9. Light Kit Assembly (Optional).
Remove 1 screw from motor plate on underside
of motor housing and partially loosen the other
2 screws. Align slotted holes in center of fitter
plate with loosened screws in motor plate,
allowing molex connections from motor housing
to come through hole in middle of fitter plate.
Twist fitter plate to lock. Re-insert screw that was
just removed and securely tighten all 3 screws
with a Phillips screwdriver.
Remove 2 screws located on underside of fitter
plate and partially loosen the other screw.
Connect WHITE wire from motor housing to
WHITE wire from light kit. Connect
BLACK) wire from motor housing to
from light kit. Be sure molex connections snap
together securely.
Carefully arrange wiring within fitter plate. Align
one of the holes on the outer rim of the LED light
kit with the loosened screw in the fitter plate.
Then, slide the LED light kit toward the loosened
screw until they fit correctly. Re-insert the
2 screws that were previously removed and
tighten all 3 screws securely.
To attach shade, align grooves on shade with
nodules on inside of fitter plate and push up
gently on shade. Turn shade to the RIGHT
(clockwise) until shade locks into place.
Pull down VERY GENTLY on shade to make
sure that shade is secure.
If you do NOT wish to use the light kit,
grooves in metal cover with nodules on inside
of fitter plate. Push up on metal cover and then
turn metal cover to the
no longer turns.
WARNING: Metal cover will be HOT if light is left
on.
BLUE (or
BLUE
wire
align
RIGHT (clockwise) until it
motor
plate
molex
connections
molex
connections
fitter plate
shade
fitter plate
metal cover
page 10
motor
housing
fitter
plate
motor
housing
fitter
plate
LED light kit
motor
housing
LED light kit
nodule
groove
motor
housing
LED light kit
nodule
groove