Craftmade Sterling STL60 Guia De Instalacion página 9

7. Canopy Assembly.
Locate 2 screws on underside of hanging
bracket and remove screw closest to the open
end of the hanging bracket. Partially loosen the
other screw. Lift canopy to hanging bracket.
Place rounded part of slotted hole in canopy
over loosened screw in hanging bracket and
push up. Twist canopy to lock. Re-insert screw
that was removed and then tighten both screws
securely.
Slide canopy cover up to canopy, aligning
protrusions on canopy cover with knotches in
the hole in the bottom of center of the canopy.
Press up gently but firmly on the canopy cover
until it fits into the bottom of the canopy and
then turn canopy cover to the right (clockwise)
about 1/2 in.
8. Blade Assembly.
WARNING: To reduce the risk of serious bodily
injury, DO NOT use power tools to assemble the
blades. If screws are overtightened, blades may
crack and break.
Locate 6 blade screws/lock washers in
hardware pack. Turn blade so the end imprinted
with THIS SIDE UP is turned FACING UP and
toward the motor housing. Raise blade to
motor (located on the underside of the motor
housing), aligning holes in blade with
corresponding holes in motor--refer to drawing
at right. Partially insert 2 blade screws/lock
washers. Before securing screws permanently,
repeat procedure for remaining blades.
Securely tighten all blade screws only after all
3 blades have been attached.
NOTE: Tighten blade screws twice a year.
canopy
screw
blade screw/
lockwasher
page 9
hanging
bracket
screw
canopy cover
motor
housing
blade