Publicidad
Idiomas disponibles
Idiomas disponibles
6. Wiring.
WARNING: Turn off circuit breakers to
current fixture from breaker panel and be
sure switch is turned to the OFF position.
CAUTION: Be sure outlet box is properly
grounded and that a ground wire (GREEN or
Bare) is present.
Make sure all electrical connections comply
with Local Codes or Ordinances and the
National Electrical Code. If you are unfamiliar
with electrical wiring or if the house/building
wires are different colors than those referred
to in the diagram to the right, please use a
qualified electrician.
Note: Excess lead wire length from the fan
can be cut to the desired length and then
stripped.
DANGER: If using this fan in a WET location,
this fan must be connected to a supply
circuit that is protected by a Ground Fault
Circuit Interrupter (GFCI) to reduce the risk
of personal injury, electrical shock or death.
When downrod is secured in place on the
hanging bracket, wire the RECEIVER with
wire connectors provided as shown in
diagram at right.
Tip: While you are wiring, keep in mind that
wires must not obstruct receiver from
sliding into hanging bracket.
*Wrap each wire connector separately with
electrical tape as an extra safety measure.
Gently insert receiver (flat side up) into
hanging bracket and carefully push wires
and taped wire connectors into outlet box.
Let antenna rest outside of hanging bracket.
ground (green
or bare)
blue
white
red
yellow
gray
from fan
from
receiver
gray
yellow
red
white
blue
(wiring for receiver)
page 8
white supply wire
black supply wire
ground (green)
from
ceiling
from
receiver
antenna
white
AC IN N
black AC IN L
ground (green/yellow)
receiver
*
Publicidad
