Kohler K-1579 Instrucciones De Montaje página 6

Drain Overflow Tube
5-3/4"
(14.6 cm)
2. Drain Installation
Install the drain to the whirlpool according to the drain manufacturer's instructions. Do not connect
the trap at this time.
When using the K-11660 drain or K-7160-TF Kohler drain, field modification of the drain is
necessary. If you are using the K-11656 Kohler drain, no modification is necessary. If another
manufacturer's drain is used, make sure it is the right size and fits properly.
Using the K-11660 Kohler Drain
Using a tubing cutter, cut the overflow tube to 5-3/4" (14.6 cm) as shown.
Replace the current lift wire with the lift wire enclosed in the plastic bag containing the installation
instructions. With a pliers, bend the loops at both ends of the current wire to remove it from the
drain. Install the new wire.
Refer to the instructions packed with the drain for the remainder of the installation.
Using the K-7160–TF Kohler Drain
Cut the linkage and overflow tube to the proper heights. (The drain linkage instructions will instruct
you to cut the linkage only.)
Using a tubing cutter, cut the overflow tube to 5-3/4" (14.6 cm) and the linkage to length "Y" as
shown.
Refer to the instructions packed with the drain for the remainder of the installation.
1015054-2-B
Lift Wire to be
Replaced
K-11660
Drain Overflow Tube
5-3/4"
(14.6 cm)
K-7160-TF
6
Using a wire
cutter or pliers,
cut the linkage
Y
at this end for
length "Y".
Kohler Co.