Descargar Imprimir esta página

ArmorAll AA12V2 0901 Manual Del Usuario página 7

Publicidad

Idiomas disponibles

Idiomas disponibles

1
4
8
OPERATING INSTRUCTIONS: DRY VACUUMING
The vacuum can be used as assembled or with one of the included nozzles. For use with the
crevice tool or detail brush:
1. Verify that the switch is in the OFF position before plugging in (Fig. 1).
2. Insert the the crevice tool to the end of the dust cup until secured in place (Fig. 2). The product
can be used with the crevice tool to clean between tight spaces.
3. Attach the detail brush to the end of the crevice tool (Fig. 3). The product can be used with the
detail brush to clean scratch-prone surfaces such as consoles or car vents.
4. Insert the 12V power plug into the 12V power socket (Fig. 4).
NOTICE: Vehicle will typically need to be in 'ACCESSORY' mode in order for power to be supplied to
the socket.
5. Turn the vacuum on by sliding the switch to the ON position and begin vacuuming (Fig. 5).
6. After use, turn the vacuum off and disconnect the plug from the 12V power socket (Fig. 6).
7. Remove detail brush from the crevice tool (Fig. 7).
8. Remove the crevice tool from the dust cup (Fig. 8).
9. Remove the dust cup by pressing down on the dust cup release button and pulling the dust cup
away from the vacuum. Remove the reusable washable filter by pulling on the tab at the top of the
filter. Refer to page 9 for removal instructions.
10. Empty the dust cup, clean and dry the inside and outside before storage (Fig. 9 & 10).
2
5
6
9
7
3
7
10

Publicidad

loading