C-LITE C-SPC-A-WTD Serie Guía Rápida

INSTALLATION INSTRUCTIONS
C-SPC-A-WTD Series
CAUTIONS
IMPORTANT SAFEGUARDS
When using electrical equipment, basic safety
precautions should always be followed including the
READ AND FOLLOW ALL
SAFETY INSTRUCTIONS
1. DANGER- Risk of shock- Disconnect power before
installation.
DANGER – Risque de choc – Couper l'alimentation
avant l'installation.
2. This Product Must Be Installed In Accordance With The
Applicable Installation Code By A Person Familiar With
The Construction And Operation Of The Product And The
Hazards Involved.
Ce Produit Doit Être Installé Selon Le Code D'installation
Pertinent, Par Une Personne Qui Connaît Bien Le
Produit Et Son Fonctionnement Ainsi Que Les Risques
Inhérents.
3. Suitable for wet locations.
Convient aux emplacements mouilles.
4. Wall mount only.
Installation murale seulement
SAVE THESE INSTRUCTIONS
FOR FUTURE REFERENCE
INSTALLATION OF 42" ARM VERSION
NOTE: This fixture is intended fro 120V operation ONLY.
NOTE: See Figure 1 for parts of fixture head.
1. Remove handle screw from fixture head, position handle, and use
screw to attach handle to fixture. See Figure 2.
2. Attach fixture head to arm using the hand knobs included in hardware
bag. Make sure the provided fender washer is positioned between
the fixture yoke and the arm to allow for easy rotation of the fixture.
One split washer should be used under each knob to prevent
loosening of the knobs. See Figure 3.
3. Use the included cord clips to secure the power cord in position along
the arm.
4. Choose a mounting location near an appropriately rated 3-prong
outlet which is next to or between dock door openings. See Figure 4.
5. Attach the arm mounting bracket at the chosen location using 1/4"
fasteners (provided by others) appropriate for the mounting surface.
Fastener length should be a minimum of 3". See Figure 5.
6. Plug the fixture into an appropriately rated 3-prong outlet. Use the
ON/OFF switch to operate the fixture.
7. Fixture can be fully articulated using the adjustable arm. It can also
be rotated and tilted by loosening the hand knobs on the fixture head
or the yoke. Once properly aimed, the hand knobs can be tightened
to secure the fixture head in place. See Figure 6.
following:
http://lighting.cree.com/warranty
Document: LPN00711X0001A0_A
Created By: TMT
FIGURE 1
FIGURE 2
FIGURE 3
FIGURE 4
| 1-800-236-6800
Date 4-05-2023
FIXTURE YOKE