EGO COMMERCIAL STX4500 Manual Del Operador página 21

MOUNTING AND ADJUSTING THE LOOP HANDLE
WARNING:
assembling parts, making adjustments, cleaning, or when the product is not in use.
1. Stop the motor and remove the battery pack, if installed.
2. Loosen the wing nut and remove the quick-release lever, clamping block, and
wing nut from the loop handle (Fig. 2a).
WARNING:
kit ABB1203-1, sold separately), the safety barrier bar must be installed onto the loop
handle.
3. Push the loop handle onto the shaft between the threshold ring and the warning
label, make sure that the loop handle is positioned upwards and points toward the
top of the rear handle (Fig. 2b).
4. Insert the clamping block into the handle slot (Fig. 2c).
5. Align the recessed part in the barrier bar with the protruded part on the loop
handle, press the barrier bar onto the loop handle (Fig. 2d).
6. Mount the quick-release lever and tighten the wing nut (Fig. 2e).
7. Pull the quick-release lever up to move/rotate the loop handle to a comfortable
operating position (Fig. 2f).
8. Fold the quick-release lever to secure the loop handle in place (Fig. 2g).
WARNING:
56-VOLT LITHIUM-ION COMMERCIAL 17.5" STRING TRIMMER — STX4500/STX4500-FC
Always remove the battery pack from the product when you are
When the machine is used with brush cutter head (part of the EGO
Never use the machine without the loop handle securely attached.
21