ELEMENTI IEB-L91 Manual página 8

2，lighting the fire
1.Dip the lighting rod tip into the chamber
opening "Burner zone" to wet the end.
2.Lift the lighting rod away from the Burner (do not
drip fuel on the floor).
3.Lgnite the lighter and make contact with the
lighting rod as if lighting a candle.
4.Dip the ignited lighting rod back into the
Burner zone to ignite the contained fuel .
NOTE: The IEB-L91 is best ignited from the
right hand side of the ignition zone.
5.Allow residual flame on lighting rod to burn out.
Once lit there will be a residual flame on the lighting rod that must burn out before putting the rod away.
If the flame on the lighting rod dies before reaching the burner, repeat the procedure until successful.
3, Turning your burner OFF
For Round burner:
Place the lid on top of the burner making
sure it fits into its position.
HOW TO OPERATE THE BURNER
For Linear burner:
Using the Sliding Lid Handle, push the Sliding Lid to
the front / closed position. Should the flame not
extinguish with the first try please repeat until
extinguished.
8 / 52