Wetrok Master Sweep 97 Plus Manual De Instrucciones Original página 49

7.3 Set hold-down device
With the hold-down device, the right plate broom
is adjusted to the edge regions to be swept, for
example on walls or curbs.
NOTE
An unsuitable setting of the hold-down device
at lower edges can lead to excessive wear.
The hold-down device must not scratch on the
ground.
1
Fig. 14: Hold-down device setting
Sweeping out edges and corners
• Press down the handle (1) of the hold-down
device.
Operation on surfaces
• Pull up the handle of the hold-down (1) device.
7.4 Battery operation and LED display
1
Fig. 15: Use and display
The LED display (2) communicates the operating
state of the battery-operated sweeping machine.
• Place the sweeping machine on the surface to
be swept.
CAUTION
Do not operate the on/off switch with your
foot.
This may cause injury by causing you to fall
or stumble when the plate brooms on the
sweeping machine begin to move.
• Only switch the machine on by hand.
• Switch on the sweeping machine by switching
the on/off switch (1) to position I.
The plate brooms and fine sweeping rolls begin
to rotate. The LED display (2) will show green
during battery operation provided there is
sufficient charge.
Operation
EN
2
49