Omnitronic CDP-385 Manual Del Usuario página 26

All manuals and user guides at all-guides.com
Read a program:
After entering your last song, press the Play/Pause-button. The program will be played back.
Delete a program:
In order to leave the program mode press the Prog.-button and hold it for approx. 3 seconds or open the CD
tray or switch the device off.
6.7 CUEING
Auto-Cue function:
After switching on or after pressing the Skip-buttons, the player automatically jumps to the section where the
music starts. This fuction enable to minimize the transitions between two tracks.
Back-Cue function:
If you press the Cue-button during playback, the player returns the position where the playback started and
goes into Pause-mode.
Memorizing the Cue-point:
Possibility 1:
The player is in Playback-mode.
Press the Play/Pause-button and the player goes into Pause-mode.
Press the Play/Pause-button and the player goes into Playback-mode. The Cue-point was memorized at the
position where you started the playback.
As soon as you press the Cue-button, the player returns the Cue-point and goes into Pause-mode.
Possibility 2:
The player is in Playback-mode.
Press the Play/Pause-button and the player goes into Pause-mode.
Select the Cue-point via the Search/Scan-buttons. The display shows the starting-point (e.g. 3:42 22).
Press the Play/Pause-button and the player goes into Playback-mode. The Cue-point was memorized at the
position where you started the playback.
As soon as you press the Cue-button, the player returns the Cue-point and goes into Pause-mode.
6.8 Relay-operation
In the Relay-operation, the device automatically switches to the other player after every track. In this way,
you have the possibility to enlarge the music program by using several CDs.
Connect the Control-sockets of the two CD-players with one another. The Relay-button must remain
unpressed (LED off).
Press the Single-button (The display shows "SINGLE") on both CD-players. Start playback of CD1. As soon
as the current track of CD1 is finished, the player automatically starts CD2. The first CD-player goes into
Pause-mode. You can enter a new CD or memorize a Cue-point at the respective player in the Pause-Mode.
6.9 Faderstart
With the CDP-385, you have the possibility to start the respective CD-player direcatly from the mixer. Make
sure that the Control-socket is connected with the respective socket on the mixer. Additionally, the Audio
Out-sockets have to be connected with the Line-input sockets of your mixer. Please note that the Faderstart-
function only works with the appropriate mixers. Insert the CD and select the desired track (Pause-mode).
Start playback from your mixer.
Please note that the Faderstart-function is a Cue-point Faderstart-function. This means that the CD-player
starts playback after activating the respective channel of the mixer and goes into Pause-mode and returns to
the Cue-point after activating the channel again.
Prerequisites for the Faderstart-operation:
The mixer has to be connected via a 3.5 mm mono jack with the CD-player. For starting the playback, the
jack's positive pin (tip) is to be connected with the audio mass via a short impulse. For pausing the playback,
the jack's negative pin (sleeve) is to be connected with the audio mass via a short impulse. The mixer has to
26/51 1060225N_V_1_0.DOC