Publicidad
Idiomas disponibles
Idiomas disponibles
BEFORE THE FIRST OPERATION
For the perfect taste, operate the jug kettle with fresh water in order
to clean any residue left from the manufacturing process. When the
appliance has cooled down, repeat the process 3 times with fresh
water, before rinsing.
OPERATION
Always remove the jug from the power base before filling it or
•
before any operation.
Open the lid and fill the tank with fresh water, paying attention
•
not to fill under the minimum mark and above the maximum
mark on the water level indicator.
Close the lid by pressing it down. Make sure it closes correctly.
•
Make sure the spout filter is well in position, as also the auto-shut
•
off feature would not work.
Put the jug onto the power base, plug into the wall socket and
•
switch on by pressing down the switch situated on the handle. The
blue pilot light comes on indicating the appliance is operating.
The jug kettle will switch off automatically when the water has
•
boiled. However, you can stop the jug kettle anytime by putting
the switch in off position.
For instant re-boiling, wait until water has cooled down and
•
switch on the appliance again.
SAFETY CUT-OUT
This jug kettle is protected with an automatic safety device if
•
accidentally switched on without water. Please bear in mind that
only the thermostat is switched off in case of overheat, whereas
the switch stays in ON-position.
In this case, switch off the appliance by putting the switch in OFF
•
position and wait about 10 minutes for the element to cool. Then
pour in sufficient cold water to cover the element. This will reset
the safety device.
The kettle may then be used as normal.
•
5
USK JK 33006 - 100907
Publicidad
