Publicidad
Idiomas disponibles
Idiomas disponibles
Before working on the pneumatics:
f Check the main shut-off valve.
f Switch the device off (see Operating Instructions, "Supporting documents", page 36).
f Before opening or removing a tube, make sure that it is not pressurized.
2.7.6
Hazardous materials
Milling materials
Depending on the material of the milled discs / blocks, without appropriate safety
measures during processing there is a risk respiratory problems caused by inhaling
hazardous milling dust or chips, residues or emissions.
f Only use the device when the suction is switched on.
f Use only discs / blocks that do not present a hazard to health when the suction system is
properly used.
f Only operate the suction system with the filter specified by the manufacturer.
f In order to prevent subsequent work from being damaged, always clean the device
before and after processing CoCr alloys.
f When extracting carcinogenic materials and/or welding fumes from materials with a
nickel or chrome content, the technical rules for the handling of hazardous substances
TRGS 560 regarding air recirculation in connection with the treatment of carcinogenic
hazardous materials must be complied with.
Coolant fluid/concentrate
f Without appropriate safety measures there is a risk of skin irritations, allergic reactions
and respiratory problems.
f Observe the specifications in the Safety Data Sheet PrograMill Fluid ("Supporting
documents", page 36).
Safety
45
Publicidad
