Electrolux ESF 45030 Manual De Instrucciones página 32

32 electrolux
3. If you use a washing programme with
prewash phase, put more detergent in
the prewash detergent compartment (B).
B
4. If you use detergent tablets, put the de-
tergent tablet in the detergent dispenser
(A).
Multitab function
The multitab function is for combi detergent
tablets.
These tablets contain agents such as deter-
gent, rinse aid and dishwasher salt. Some
types of tablets can contain other agents.
Do a check if these tablets are applicable for
the local water hardness. Refer to the in-
structions from the manufacturer.
When you set the multitab function, it stays
on until you deactivate it.
The multitab function stops automatically the
flow of rinse aid and salt. The rinse aid indi-
cator light and salt indicator light are deacti-
vated.
The programme duration can increase if you
use the multitab function.
Activate or deactivate the multitab func-
tion before the start of a washing pro-
gramme.
You cannot activate or deactivate the
multitab function when the programme
operates. Cancel the washing pro-
gramme, then set the programme again.
To activate the multitab function:
• Press the multitab button. The multitab in-
dicator light comes on.
A
5. Close the lid of the detergent dispenser.
Press the lid until it locks into position.
Different brands of detergent dissolve in
different times. Some detergent tablets
do not have the best cleaning results
during short washing programmes. Use
long washing programmes when you
use detergent tablets to fully remove the
detergent.
To deactivate the multitab function:
• Press the multitab button. The multitab in-
dicator light goes off.
Do these steps if the drying results
are not satisfactory:
1. Fill the rinse aid dispenser with rinse
aid.
2. Activate the rinse aid dispenser.
3. Set the rinse aid dosage to position
2.
• You can only activate or deactivate
the rinse aid dispenser when the mul-
titab function is activated.
To activate/deactivate the rinse aid dispens-
er:
The appliance must be switched off.
1. Press and hold the start/cancel button.
Turn the programme knob counterclock-
wise until the programme marker agrees
with the first washing programme on the
control panel.
2. Release the start/cancel button when the
display shows the water hardness level.