3
Use
c
aution
Your equipment and your tow rope:
- Inspect all equipment prior to use. Check your per-
sonal flotation device prior to each use and do not use
if damaged.
- Tow ropes stretch during use. If a rope breaks or is
suddenly released, it can snap back striking the boat
occupants or the user which could result in injury or
death.
- Inspect the rope and connecter for frays, cuts, sharp
edges, knots, or wear before use.
- Do not use the tow rope if damaged, as it may break.
- Use a proper tow rope for the activity and load.
- Ensure each rope is clear of the rider prior to starting
out or during use.
- Keep persons and ropes away from the propeller when
the engine is running, even in neutral. Should the rope
become entangled in the propeller, SHUT OFF THE
ENGINE AND REMOVE THE IGNITION KEY BEFORE
RETRIEVING THE ROPE.
- Tow ropes and tubes are subject to deterioration when
exposed to direct sunlight. The life of the product will
be extended when stored away from sunlight.
c
aution
When towing a tube:
- Familiarize yourself with all applicable federal, state,
and local laws, as well as the risks inherent in the
sport, the use of protective gear, and the proper use
of the equipment.
- Know the waterways, exercise caution, and use com-
mon sense.
- Never start out until the rider(s) signals they are ready.
- Shut the engine off and remove the ignition key before
retrieving your tow rope.
W
arning
When you ride on a tube:
- Attempting land or dock starts increases the risk of in-
jury or death. USE THIS PRODUCT ONLY ON WATER.
- Do not tube in shallow water or near shore, pilings,
docks, rafts, swimmers, other boats, or other obsta-
cles.
- The driver must watch for and be able to stop or turn
to avoid obstacles.
- Always ski or ride in control and at speeds appropriate
for your ability. Ride comfortably and well within your
limits.
8
Next level leisure
- Stop when you are tired. You should be in good phys-
ical condition and be cautious in your use of this or
other towables.
- Do not use this tube over ramps or jumps.
- Falling and the injuries that may result from that are
inherent risks in the sport.
- Do not ride this tube under the influence of alcohol
and/or drugs.
4
Assembly
The inflation instructions below will vary depending on
the model you have purchased:
1. Spread the nylon cover out on the floor.
2. Unzip the opening on the cover when applicable.
3. Gently inflate the safety chamber of the PVC tube.
4. Insert the PVC tube through the zipper opening on the
cover. Be sure to align the Boston valve on the PVC
with the round opening on the cover.
5. Grab the edge of the tube and the edge of the cover
and shake them up and down together to smooth out
the PVC tube inside. Keep the Boston valve aligned
correctly as this will make the inflation of the tube eas-
ier.
6. When applicable, zip the cover closed before full in-
flation. Make sure the zipper does not catch the PVC
tube.
7. Inflate the main chamber of the tube using a high-vol-
ume/low-pressure pump.
c
aution
If you notice a slow air leakage, make sure that the valve
end cap is installed straight and tight and the valve is not
cross threaded.
Please make sure not to overinflate the tube. The tube
should be full, but not too firm. Overinflation could rup-
ture the tube.
EN