CASO DESIGN MIG 25 Manual Del Usuario página 67


After cleaning the interior space, leave the oven door open until the interior of the device
is completely dry.
 Front of device and operating panel

Clean the front of the device and the operating panel with a soft, slightly damp cloth.

Please bear in mind that the operating panel does not get wet. Use a soft, damp cloth
for cleaning.
► Leave the oven door open to prevent the device from being re-started accidentally.
 Exterior housing

Clean the exterior surfaces of the device with a damp cloth.
 Glass turntable, grill rack and rolling ring

The glass turntable, grill rack and rolling ring must be removed and cleaned
occasionally. Wash the glass turntable, grill rack in a warm soapy solution or in the
dishwasher.

The rolling ring should be cleaned regularly to prevent excessive noise development or
a rotational malfunctions. The rolling ring can be washed in a mild soapy solution or in
the dishwasher. Please remember to put the rolling ring back again properly after
cleaning it.

Wipe the bottom of the oven with a mild cleaning agent. If the floor of the oven is
excessively dirty, you can use a mild cleaning agent.
15 Troubleshooting
This chapter provides you with important notices with regard to operating the device.
Observe the following notices to avoid dangers and damages:
15.1 Safety notices
► Only qualified electricians, who have been trained by the manufacturer, may carry out
any repairs on electrical equipment.
► Improperly performed repairs can cause considerable dangers for the user and
damages to the device.
15.2 Fault indications
In the event of a fault, an error code will appear in the display; it describes the cause of the
fault.
Error code
E-01
Please note
Attention
Description
The display shows E1 and you can here a signal tone. Press .
67