Genesis GBS900 Manual Del Operario página 8

UnPACKing AnD COnTEnT
iMPOrTAnT:
unlikely the tool is faulty or that a part is missing. if you find anything
wrong, do not operate the tool until the parts have been replaced or the
fault has been rectified. Failure to do so could result in serious personal
injury.
Contents in Package:
Description
Band Saw
Rip Fence
Miter Gauge Assembly
Allen Wrench
WArning:
assemble the saw, plug in power cord or turn the switch on until the missing or
damaged parts are replaced.
ASSEMBLY
WArning:
from the power source before adjusting, adding accessories, or checking a
function on the tool.
Installing the Saw Table (Fig 2, 3)
1. Remove the table aligning screw and nut (1) from the table edge.
2. Place the table onto the saw. Slide the blade through the table slot (2). Make sure the mounting rib
(3) on the side of housing is engaged with the recessed groove on the rotating bracket (4).
3. Insert the flat washer on the threaded side of the table lock knob. Insert table lock knob through
the bracket slot and into the hole in the housing, turning clockwise until finger-tight. Install table
lock handle (6) over lock knob and install Allen bolt with spring into lock lever. Turn the Allen bolt (7)
clockwise with the provided Allen wrench to tighten lever to lock knob. (FIG 3)
NOTe: The spring loaded handle (6) can be released by pulling the handle outwards.
4. Replace the aligning screw and nut (1).
5. If necessary, adjust the tilt pointer (8) to reflect actual table tilt position.
1 2
4
Fig 2
NOTE : The table must be properly adjusted before operating the saw. See Table tilt adjustment.
Installing the Rip Fence
1. Raise the clamp on the rip fence to the up position.
2. Place the fence on the table so that the clamp is at the front of the table. (See FIG 1)
3. Lower the fence clamp to lock the fence in position on the table. Rotate clamp to adjust tightness.
9" Band Saw
Operator's Manual
Due to modern mass production techniques, it is
QTY
1
1
1
2
if any parts are missing or damaged, do not attempt to
Always be sure that the tool is switched off and unplugged
3
Description
Saw Table
Table Tilt Lock Handle
Operator's Manual
5
6
7
Fig 3
GBS900
QTY
1
1
1
8