Technical Data; Assembly; Commissioning; Operation - Gloria Thermoflamm bio Electro Instrucciones De Uso

4

Technical data

Thermoflamm bio Electro
Voltage:
Output:
Heating system:
Max. temperature at the nozzle:
Noise emissions
L PA :
L WA :
Weight:
Total length:
5

Assembly

NOTE!
Assembly the device in accordance with the illustrations
Ensure that the cable is fed as shown in Fig.
This must lie in a loop in the housing and must not protrude from the housing. The cas-
ing must be easy to fit in place. Ensure that the cable is not pinched or damaged.
6

Commissioning

WARNING! Danger or death by fire and/or explosion!
Improper use of the device poses a risk of serious injury or death! You should therefore
observe the following safety instructions:
Only operate the device in the open air.
The „air inlet openings" E must not be blocked or covered.
Ensure that the air outlet openings on the 'conical nozzle' J are not blocked, or the „conical
nozzle' J is not twisted and is thus hinders the hot air flow.
Never direct the hot air stream at the connection cable or at flammable or explosive
substances.

6.1 Operation

Figures 3 - 6
Slide the loop of the extension cable into the designated „cable cleat" B in the „handle" A
3
and fix it in the designated clip (see Figure 3).
NOTE!
The performance of the equipment may decrease if unnecessarily long extension cables
(>25 m) are used.
If cable reels are used, unroll the entire cable.
The cross-section of the cable used must be 1.5 mm
230 VAC ~ / 50/60 Hz
2000 Watt
Hot air stream
650 °C
70,0 dB
83,0 dB
1.1 kg
116 cm
2 .
2
.
17
– see page 2.
1 2