Publicidad
Idiomas disponibles
Idiomas disponibles
Parts are located throughout the shipping carton, including underneath the grill. Inspect the grill, parts, and hardware blister
pack after removing from the protective shipping carton. Before assembly of product, review all parts and reference the parts
list. If any part is missing or damaged, do not attempt to assemble. Shipping damage is not covered under warranty. Contact your
dealer or Louisiana Grills Customer Service for parts: Monday through Sunday, 4am - 8pm PST (EN/FR/ES).
service@louisiana-grills.com | Toll-Free: 1-877-303-3134 | Toll-Free Fax: 1-877-303-3135
IMPORTANT: To ease installation, using two people is helpful (but not necessary) when assembling this unit.
Tools required for assembly: screwdriver, wrench and level. Tools not included.
IMPORTANT: It is advised to read each step entirely before starting assembly on instructions. Do not tighten screws
completely until all screws for that step have been installed. Hardware combination involving a locking washer and
washer should be installed with the locking washer closest to the head of the screw.
1. ASSEMBLING THE CART
Parts Required:
Bottom Shelf (#16)
1
x
2
x
Short Support Leg (#9)
2
x
Long Support Leg (#10)
16 x
Screw (#D)
Washer (#E)
16 x
Locking Washer (#F)
16 x
Installation:
•
Place a piece of cardboard on the floor to prevent scratching the unit
and parts. To ease installation, turn the bottom shelf upside-down (flat
side down). Prepare the four support legs for installation, separating
the two short support legs from the two long support legs.
•
Attach one short support leg by carefully sliding it into a corner of
the bottom shelf, then secure using four washers, locking washers
and screws. Ensure the threaded hole on the bottom is on the end of
the support leg closest to the bottom shelf. Repeat installation for
the other short support leg, installing it to the corner along the same
short side of the bottom shelf.
•
Continue cart installation by securing the one long support leg to
the other side of the bottom shelf. Ensure that the wheel axle hole
is on the end of the support leg closest to the bottom shelf. Repeat
installation for the other long support leg on the last corner.
ASSEMBLY PREPARATION
ASSEMBLY INSTRUCTIONS
1
7
Publicidad
