Optional Liners (Pm300Ss Unit Only); Remove The Cabinet Brackets - Broan BBN1243SS Instrucciones De Instalación, Uso Y Cuidado

OPTIONAL LINERS
(PM300SS UNIT ONLY)
For installations where the PM300SS unit is less than 30"
above cooktop, this powerpack insert should be mounted into
a metal liner (FIG . 2) to protect cabinetry combustible material
from heat, in order to meet building code requirements . This will
allow easier cleaning and provide protection to the cabinetry .
Refer to table at right to find the liner model corresponding to
the cabinet style and width .
Visit www .broan-nutone .com or www .broan-nutone .ca to view
specific model information .

REMOVE THE CABINET BRACKETS

(BBN1243SS AND BBN1303SS UNITS
ONLY)
Detach the cabinet brackets (grey part in FIG . 3) from the back
of the powerpack insert by removing its 2 retaining screws .
Discard the screws .
Fold up and down the bracket until it is split in two separate
parts (FIG . 4) . Keep the brackets for possible further use .
NOTE: Both cabinet brackets have one wide edge and one
narrow edge (FIG . 5), to cover all installation
configurations depending on cabinet widths .
6
METAL LINER
HD1051
L C
iner modeL
LB30SS
LB36SS
SCREWS
HD1370
HO0413
Narrow edge
Wide edge
HO0408
FIG. 2
abinet nominaL width
30"
36"
FIG. 3
FIG. 4
FIG. 5