Publicidad
Idiomas disponibles
Idiomas disponibles
Mig W
SETUP FOR GASLESS MIG (DCEN) PROCESS
PLUG
ground clamp cable into positive socket and twist clockwise to lock in place
PLUG
wire feed cable into negative socket and twist clockwise to lock in place
CLEAN
weld surfaces with brush or grinder until no rust, paint, oil, or other materials remain on weld surfaces
ATTACH
ground clamp to bare metal on the workpiece or to metal work bench where workpiece is clamped
PLUG
machine into properly grounded GFCI protected receptical
PRESS
the switch to set the MIG welding process
SET
MIG torch down on nonconductive, nonflammable surface, away from grounded objects
TURN
power switch on
ADJUST
the wire speed, voltage, and inductance knobs to desired settings (see setup chart inside machine)
ENSURE
correct diameter contact tip and nozzle are installed on torch
HOLD
torch trigger until wire feeds through contact tip and extends 1/2" beyond nozzle
Start by setting recommended amperage and adjust as necessary.
ELdiNg
See setup chart inside machine cover.
www.ktindustries.net
PAGE | PAGE | PÁGINA
ER71-T-GS
7
®
®
FLUX CORED (DCEN)
GASLESS WIRES DC(-)
Publicidad
