Hoshizaki DCM-120FE Manual De Instrucciones página 5

ENGLISH
mechanical problems. For efficient use
of ice, turn off the Ice Making Switch
before shutting down the ice dispenser.
Ice remains available until the Storage
Bin becomes empty, and water is always
available.
Operation Panel
[] [2]
[5]
[4]
[3] [2]
[] Display
[2] Portion Control Lamp
[3] Ice Switch
[4] Ice & Water Switch
[5] Water Switch
[6] Power Lamp
[7] Ice Making Lamp
[8] Lock Lamp
[9] Cleanup Lamp
[0] Service Call Lamp
[] Portion Control Switch
[2] Drain Switch
[3] Set Switch
[4] End of Drain Cycle
[5] Drain Cycle
Fig. 4
1. OPERATION - How it works
Water flows from the potable water source through
the water tap, and enters at the water inlet fitting
and on to the Reservoir. The Reservoir functions to
maintain a constant water level inside the Freezer
Assembly. Water from the Reservoir enters at
the bottom of the Freezer. Heat is removed by
the refrigeration process and ice forms inside the
Freezer.
A stainless steel Auger inside the Freezer is direct-
driven by the Gear Motor, and the rotating Auger
carries the ice upward to the top of the Auger,
where excess water is pressed out of the ice,
before being extruded and broken into cubelet ice
All manuals and user guides at all-guides.com
[3] [4] [5] [6] [7]
[] [0] [9] [8]
(compressed ice) and then pushed out into the Ice
Storage Bin.
Moving the Power Switch and the Ice Making
Switch, located on the bottom left of the Middle
Front Panel, to the "ON" position starts the
automatic and continuous ice making process.
When the Ice Storage Bin is filled with ice, the Bin
Control Switch will shut off the ice making process.
As the ice is dispensed from the Storage Bin, the
Bin Control Switch will reset automatically and
restarts the ice making process.
Pushing one of the Select Switches, located on the
right side of the Middle Front Panel, gives the user
convenient 3-way dispensing - Ice, Ice & Water, or
Water.
Pushing the Portion Control Switch, located on
the right side of the Middle Front Panel, and
illuminating the Portion Control Lamp will activate
the preset portion control for ice dispensing. If
adjustment is desired, see "3. ADJUSTMENT OF
ICE PORTION CONTROL".
An agitator mechanism in the Storage Bin functions
to give a smooth ice flow and to prevent making an
ice block.
2. START UP
) Plug in the ice dispenser.
2) Open the water tap.
3) Move the Power Switch, located on the bottom
left of the Middle Front Panel, to the "ON"
position. The Power Lamp lights up.
4) Move the Ice Making Switch, located on the
bottom left of the Middle Front Panel, to the
"ON" position. The Ice Making Lamp lights up,
and the ice dispenser starts the automatic ice
making process.
5) Check the water supply and drain connections
for water leaks.
6) The initial ice making process will be completed
within 0 minutes of the Ice Making Switch
being moved to the "ON" position.
7) Push the Ice Switch on the Operation Panel.
8) Press the Push Lever, and check for proper ice
dispensing action.
4