Hoshizaki DCM-120FE Manual De Instrucciones página 7

ENGLISH
Cycle sign when the cycle completes. The
drain cycle may not begin immediately after the
Drain Switch is pressed.
6) Replace the Apron Panel A in its correct
position. See "3. ADJUSTMENT OF ICE
PORTION CONTROL".
7) Move the Power Switch, located on the bottom
left of the Middle Front Panel, to the "OFF"
position.
8) When preparing the ice dispenser for long
storage or subfreezing conditions, wipe the
Drain Pan and Grille dry, and unplug the ice
dispenser.
III. MAINTENANCE
1. CLEANING
WARNING
 . B e f o r e c a r r y i n g o u t a n y c l e a n i n g o r
maintenance operations, unplug the
ice dispenser from the electrical supply
network.
2. Ask a trained service person to clean and
sanitize the ice dispenser water system at
least twice a year and to check and clean
the Condenser at least once a year.
3. This appliance must not be cleaned by use
of a water jet.
[1] Exterior
Wipe the exterior at least once per week with a
clean, soft cloth. Use a damp cloth containing a
neutral cleaner to wipe off grease or dirt.
[2] Grille, Apron Panel A, Water Pipe, Spout
Wipe these parts with a clean, soft cloth. To
remove the Grille, lift it up and pull it toward you.
To remove the Apron Panel A, turn the two screws
on both sides with a coin, and pull the panel toward
you. Then remove the Water Pipe by releasing
the Clip, and remove the Spout by pulling it toward
you. Use a damp cloth containing a neutral cleaner
to wipe off grease or dirt.
All manuals and user guides at all-guides.com
Spout
To reinstall the Spout, fit the Hook into the Lower
Slot on the Apron Panel B, then push the Tab into
the Upper Slot.
Water Pipe Installation
To prevent dripping after water dispensing, do not
slant the Water Pipe as shown below. Keep the
Water Pipe upright when installing it on the Spout.
6
OPEN
Apron Panel A
Pull toward
you
Clip
Spout
Water Pipe
Lift up
Apron Panel B
Grille
Air Filter
Fig. 5
Spout
Hook
Fig. 6
CLOSE
Tab
Upper Slot
Lower Slot
Apron
Panel B