Sunoptic Surgical Titan 400HP Manual De Uso página 9

5.2 CONNECTING THE LIGHT CABLE
Connect the light cable to instrument and then plug the light cable endfitting into the
appropriate port of the turret on the front panel.
NOTE Approved cables for use with the TITAN 400 are: SG-0080, SG-0083, SG-
0087, SG-0088, SG-0089, SG-0090, SL-0080, SL-0083, SL-0087, SL-0088, SL-0089
AND SL-0090
.
6. OPERATION
6.1 POWERING UP THE LIGHT SOURCE
To operate the light source: Attach the light source to the instrument or headlamp.
Turn on the rear power switch. Turn on the lamp switch. The fan will start. The
indicator on lamp switch will light. The lamp will ignite.
6.2 LIGHT BRIGHTNESS DISPLAY AND CONTROL
The light brightness adjustment enables the user to obtain a brighter or darker
illumination of the object of observation.
Adjust the light intensity by turning the intensity control knob.
6.3 LAMP LIFE HOURS DISPLAY
The hour meter shows the total elapsed running time of the unit.
7. CLEANING
NOTE Always disconnect the power cord before cleaning the system.
The control unit can be cleaned with any cleaning agents, which are used for external
cleaning of electric equipment, according to instructions given by the manufacturer of
the cleaning solution.
Do not allow excessive moisture or liquids to come in direct contact with the control unit.
Do not use cleaning agents that are not permitted for use with plastics, i.e., ammonia,
acetone, salty acids (HCl), etc.
Do not allow cleaning agents or liquids to enter the control unit outlets or vents at side,
back or bottom of the unit.
LIT124SUNOPTICS SURGICAL
(English)
®
Rev. G
Page 9 of 65