LEGRAND C2G31020 Manual Del Usuario página 4

HDMI® HDBaseT + 3.5mm, USB-A, and RS232 over Cat Audio De-Embedding
Extender Box Receiver - 4K 60Hz
Product Overview
Front Panel
① ② ③ ④
F P D
RONT ANEL ESCRIPTION
On: Power is applied to the device.
1 P LED
OWER
Off: No power is applied to the device.
Blinking: The device is working properly.
2 STATUS LED
Off: The device is not working properly.
On: HDCP protected content is being transmitted.
3 HDCP LED Blinking: Non-HDCP protected content is being transmitted.
Off: No content is being transmitted.
On: HDBT link is normal.
4 LINK LED
Off/Blinking: No HDBT link or link error.
Set the function of RS232 port.
• PASS-THROUGH (Default): RS232 port is used for RS232
commands pass-through over HDBT.
5 RS232 DIP S
WITCH
• MCU: RS232 port is used to update MCU firmware.
• VS: RS232 port is used to update Valens firmware of
transmitter and receiver.
Receiver
⑤
Rear Panel
⑥ ⑦
R P D
EAR ANEL ESCRIPTION
6 DC 12V DC 12V power input; connect to the power adapter provided.
Connect to HDBT OUT of the transmitter via a Cat 5e/6/6a/7 cable.
7 HDBT IN
With POH OUT, the transmitter can be powered by this receiver.
For RS232 pass-through or firmware upgrade, and can be set through
8 RS232
DIP switch on front panel.
9 HDMI OUT Connect to an HDMI display using an HDMI cable.
Unbalanced stereo audio output.
DE-EMBED: For audio de-embedding from the HDMI output.
10
2x AUDIO OUT
PASS-THROUGH: For audio pass-through from Audio In port on the
transmitter to this port.
Connect to USB devices such as keyboard, mouse, USB camera, etc.
Note: USB ports support USB 2.0 standards with a maximum of 1.4A
11 4x USB-A
for the top two ports and 0.6A on the bottom two ports. USB cameras
are recommended to be connected into one of the top two 1.4A ports.
2
Receiver
⑧ ⑨ ⑩ ⑪
(us)
(us)