PROMEBA PS-190 Manual De Instrucciones página 56

USER GUIDE
ELECTRIC CHAIR
07
GENERAL MAINTENANCE
07.1. Cleaning
It is essential to keep the equipment clean to ensure proper use and durability of the set.
Thorough cleaning should be carried out periodically, especially in areas exposed to dirt that
can accumulate dirt such as corners or holes.
Es fundamental mantener limpio el equipo para asegurar un correcto uso y durabilidad del
conjunto. Se debe realizar una limpieza a fondo periódicamente, especialmente en áreas
expuestas a suciedad que puedan acumular suciedad como esquinas o agujeros.
Do not use high pressure cleaning systems or bleach to disinfect the product, they can
damage it. Instead, use a hydroalcoholic-based
disinfectant, wash it with water and let it dry naturally,
do not use direct heat sources to dry.
Non-compliance with cleaning operations can lead to
the risk of cross infections due to the presence of
secretions and/or residues. During all control and
disinfection operations, the operator must wear
appropriate personal protective equipment, such as
gloves, glasses, etc.
When the cleaning procedure includes a disinfectant
product, carefully follow the instructions of the
manufacturer of the product used regarding the
method of application and contact time. Make sure
that you have taken all the necessary precautions to
ensure that there are no risks of cross-infection or
contamination of patients and operators.
MAKE SURE TO KEEP AREAS FROM FIGURES
ON THE RIGHT FREE OF WATER AND HUMIDIT Y.
TAKE SPECIAL CARE NOT TO GET THEM WET
WHILE WASHING THE SET.
Failure to carry out the correct cleaning routine could increase the risk of cross infection, due to
presence of body fluids and/or residuals.
The operator must always wear adequate personal protection such as gloves and mask, etc. during all
checking and cleaning procedures.
07.2. Lubricating
In general, all moving parts must be greased. Our products leave the factory completely
greased and lubricated, however, it is possible that over time and use of the product the
elements become degreased, either due to loss of lubrication or due to dirt.
Periodically clean and oil affected areas according to manufacturer's specifications. Check
for loose, missing or worn parts.
Never lubricate the belts. Lubrication can cause the belts to perform unpredictably, which can
cause injury to the patient and/or operators.
EN
REV. 2023/10
56