PROMEBA PS-190 Manual De Instrucciones página 57

USER GUIDE
ELECTRIC CHAIR
07
GENERAL MAINTENANCE
07.3. Wear areas
Periodic inspection of the different components of the system for signs of wear is a
preventative measure that can reduce breakdowns. Check possible lubricant leakages,
grooves or bearing in poor condition. Check also, due to intensive usage, the moving parts
such the handles, the wheels and the folding system of the chair and the track.
In the event that a worn component needs to be changed, you should contact our sales
department for more information on ordering spare parts and their installation.
The repair or replacement of product components must necessarily be carried out by qualified
personnel, that is, who have received training from the Manufacturer, Promeba S.L. and
original spare parts should always be used.
Promeba S.L. declines any responsibility for any damage, direct or indirect, resulting from
improper use of spare parts and/or any repair intervention carried out by unauthorized
persons.
07.4. Maintenance program
Although the frequency of the controls is determined by factors such as legal requirements,
the type of use, the frequency of use, the environmental conditions during use and storage,
it is placed a recommendation on the maintenance that the equipment must have for correct
operation throughout its useful life.
All maintenance and revision activities must be recorded and documented with the
corresponding technical intervention reports, and the documentation must be kept for at least
10 years from the end of the product's useful life and must be made available to the
competent Authorities and/or from the Manufacturer, when requested.
Maintenance review
Disinfect
Clean
Inspect
Grease necessary components
Change springs
Change wheels
For both the disinfection and cleaning procedures, point 7.1 of this manual must be followed.
During the inspection procedure, which must be done after each use, the following tasks must
be carried out:
- Check that all components are present.
- Check the integrity of the device, that is, that there are no breaks, cracks, holes or
cuts.
- Check the wear of the product following section 7.3 of this user guide.
- Check that the moving parts slide correctly.
EN
REV. 2023/10
When
Every use
necessary
X
X
X X
X
Every
Every Every 4
month
year
X
X
years
X
57