Kärcher CVH 2 Manual Del Usuario página 9

This is used for cleaning joints, grooves between
2
doors and windows, tiny slits, etc.
Warranty
The warranty conditions issued by our sales company
responsible apply in all countries. We shall remedy pos-
sible malfunctions on your device within the warranty
period free of cost, provided that a material or manufac-
turing defect is the cause. In a warranty case, please
contact your dealer (with the purchase receipt) or the
next authorised customer service site.
(See overleaf for the address)
Transportation
The battery has been tested in accordance with the rel-
evant rules for international transport and can be
transported / shipped.
Storage
Note
● Store the appliance in a dry room.
● Consider the weight of the appliance when storing it.
1. Insert the appliance into the storage dock.
2. Put the crevice nozzle and the upholster brush into
accessory storage.
Care and maintenance
Note
● Use the appliance only when all filters and the dust
container are installed.
● Defective filters and filters that can no longer be
cleaned must be replaced.
Before doing any work on the appliance:
1. Switch off the appliance.
Malfunctions often have simple causes that you can remedy yourself using the following overview. When in doubt, or
in the case of malfunctions not mentioned here, please contact your authorised Customer Service.
Fault
The appliance does not
run.
Suction capacity de-
creases. / Abnormal
sound or operating noise
which becomes louder.
Electrical connection
Power frequency
Mains voltage
Voltage of charger
Working voltage of the battery
Charging time when the battery is completely dis-
charged
Battery capacity
Battery type
Protection class
Rated power
Troubleshooting guide
Possible cause
Battery is nearly empty.
The appliance is in danger of overheat-
ing.
Dust container is full.
HEPA filter set is clogged.
Technical data
2. Unplug the power supply from the power outlet.
Cleaning the filter set and the dust container
ATTENTION
Incorrect cleaning of the HEPA filter
Damage to the HEPA filter
Do not clean the HEPA filter in a washing machine.
Do not dry the HEPA filter with a hair dryer.
The HEPA filter ensures clean exhaust air.
● Clean the HEPA filter if it is visibly dirty.
● Replace the HEPA filter if it is visibly damaged.
● We recommend replacing the HEPA filter every 6
months based on your use of the device.
1. Unlock the dust container.
Illustration G
2. Unplug the filter set from the dust container. Turn the
filter cover counterclockwise. Remove the filter cov-
er, unplug the HEPA filter from the steel filter.
Illustration H
3. Clean the HEPA filter, and carefully empty / knock
the dirt out of the HEPA filter.
Illustration I
4. Empty the dust container, and rub down inside using
a cloth.
Illustration J
5. Clean the filter cover, steel filter and dust container
under running water.
Illustration K
6. Allow the filter cover, steel filter and dust container
to dry completely.
Illustration L
7. Insert the filter set into the dust container, and turn
the dust container clockwise to latch into place.
Illustration M
Remedy
1. Charge the battery.
1. Check whether the dust container is
clogged.
2. Clean the dust container.
3. Switch the appliance on again.
1. Check the dust container.
2. Check and clean the filter.
CVH 2
Hz 50 - 60
V 100 - 240
V 5
V 7.2
Minutes 180 ~ 240
mAh 2000
Li-ion
II
W 70
English
CVH 3 Plus
50 - 60
100 - 240
5
7.2
180 ~ 240
2000
Li-ion
II
70
9