Kenwood DMX129BT Guia De Inicio Rapido página 13

Installation Installation
Ñ Microphone unit
1) Check the installation position of the microphone
(accessory 3).
2) Clean the installation surface.
3) Remove the separator of the microphone
(accessory 3), and stick the microphone to the
place shown below.
4) Wire the microphone cable up to the unit with it
secured at several positions using tape or other
desired method.
5) Adjust the direction of the microphone (accessory
3) to the driver.
3
Fix a cable with a commercial item of tape.
NOTE
• Swap the clips if necessary.
Ñ Removing the trim plate
1) Use the extraction key (accessory 2) to lever out the
four tabs (two on the left part, two on the right part).
2) Pull the trim plate forward.
2
English | 13